Repair information 4-133
7002-xxx
Upper cover removal (printer)
1. Remove the ADF scan assembly. See “ADF complete assembly removal” on page 4-15
2. Remove the flatbed scan assembly. See “Flatbed scan assembly removal” on page 4-38.
3. Remove the left door. See “Printer left side cover removal” on page 4-56.
4. Remove the right cover. See “Printer right cover removal” on page 4-58.
5. Remove the upper tray cover. See “Upper tray cover removal (paper support)” on page 4-56.
6. Remove the upper sub cover. See “Upper sub cover removal” on page 4-55.
7. Remove the fuser wiper cover. See “Fuser wiper cover assembly removal” on page 4-54.
8. Remove the two screws (A) attaching the upper plenum and remove the upper plenum.
9. Remove the screw (B) at the rear of the printer and the larger screw (C) at the front on the right side.
A
To Next Page
Loading...
