Repair information 4-41
7002-xxx
Flatbed scan motor assembly removal
Illustrations represent models X644e/X646e. Unless there is an indication, the procedure is the same. Differences
are shown side by side.
1. Remove the scan cover (flatbed). See “Scan cover (flatbed) removal” on page 4-11.
2. Remove the flatbed contact glass. See “Flatbed contact glass removal” on page 4-31.
3. Remove the scanner right side cover. See “Lift the scan cover (flatbed). Scanner right side cover
removal” on page 4-12.
4. Remove the scanner left side cover. See “Scanner left side cover removal” on page 4-10.
5. Remove the three screws (A) that attach the hinge support bracket to the rear scan bracket.
6. Remove the two screws (B) from the top.
7. Remove the two screws (C) from the left side and right side.
A
To Next Page
Loading...
