Repair information 4-17
7002-xxx
CCD belt removal
1. Remove the scan cover (flatbed). See “Scan cover (flatbed) removal” on page 4-11.
2. Remove the flatbed contact glass. See “Flatbed contact glass removal” on page 4-31
3. Remove the scanner right side cover. See “Lift the scan cover (flatbed). Scanner right side cover
removal” on page 4-12.
4. Remove the scanner left side cover. See “Scanner left side cover removal” on page 4-10.
5. Push the CCD belt tension spring to take tension from the belt.
6. Unhook the belt from the motor shaft.
To Next Page
Loading...
