Diagnostic information 2-159
7002-xxx
The printer does not recognize the paper size selected
Parallel port service check
Run the “Parallel Wrap test” on page 3-10.
Note: The Parallel Wrap Test is designed to check the parallel port hardware by using a wrap plug (P/N
1319128) and invoking the Parallel Diagnostic Test. This test helps isolate the printer from the parallel cable and
host. The test provides failure information on the display for approximately three seconds. If the test indicates
that a problem is detected, replace the controller board.
FRU Action
1 Back restraint
Side restraint
Snap-in plate
Autosize slider
Autosize finger
Check all the paper size parts for damage or broken parts. make sure
the parts operate correctly. If a problem is found, repair as necessary.
If no problem is found, go to step 2.
2
Switch activate spring
Paper size sending board
Make sure the switch activate spring is not bent or broken. Replace
the spring if damaged. If the spring is not damaged, go to step 3.
3
System board
ITC cable
Set the tray for the paper size that is not recognized and install the
tray in the printer. Select the paper size and corresponding paper
switch from table, below.
If the voltage on J26 does not change, go to step 4. If the voltage
changes, recheck the printer. If Tray 1Missing is still displayed,
replace the system board assembly.
4
System board Ground the appropriate pin on connector J26 on the system board.
Tray 1 Missing should not be displayed. If it is not displayed, go
to step 5. If it still displays, replace the system board assembly.
5
Autocomp cable Check continuity of the autocomp cable. If correct, replace the ITC
assembly. If incorrect, replace the autocomp cable.
Pin
J26
Signal Static
tray out
(V dc)
Static with paper tray in and set to: (V dc)
Letter Legal A4 Exec B5 A5
1 PSIZE2 +3.3 0 0 +3.3 +3.3 0 +3.3
2Ground 0 0 0 0 0 0 0
3 PSIZE1 +3.3 +3.3 +3.3 0 0 0 +3.3
4 PSIZE3 +3.3 0 +3.3 +3.3 0 +3.3 0
5N/A
6N/A
7N/A
8 +3.3 +3.3 +3.3 +3.3 +3.3 +3.3 +3.3 +3.3
9N/A
10 N/A
To Next Page
Loading...
