Repair information 4-15
7002-xxx
ADF complete assembly removal
1. Twist the thumbscrews to disconnect the cable(s) (A) at the back of the ADF assembly.
Note: Model X642e has a single cable.
2. Remove the ADF attach screws. See “ADF attach screws removal” on page 4-13.
Note: Do not remove the two screws in the back.
3. Lift the ADF up, and make sure you clear the two rear screws. The hinge is slotted to allow the ADF to
come off and leave the screws in place.
Note: Whenever the complete ADF assembly is replaced, it is necessary to perform the scanner registration.
See “Scanner registration” on page 4-4.
A A
Model X642eModels X644e/X646e
To Next Page
Loading...
