4-38 Service Manual
7002-xxx
Flatbed scan assembly removal
Illustrations represent models X644e/X646e. Unless there is an indication, the procedure is the same. Differences
are shown side by side.
1. Remove the ADF assembly. See “ADF complete assembly removal” on page 4-15.
2. Remove the printer left side cover. See “Printer left side cover removal” on page 4-56.
3. Remove the scanner left side cover. See “Scanner left side cover removal” on page 4-10.
4. Remove the seven screws (A) from the SCC and HDD shield.
5. Loosen the screws for the printer outer shield and slide shield to the left to allow enough room to remove
the scanner control card shield and the hard disk shield.
To Next Page
Loading...
