4-124 Service Manual
7002-xxx
Paper bin full sensor flag removal
1. Remove the left door. See “Printer left side cover removal” on page 4-56.
2. Remove the upper sub cover. See “Upper sub cover removal” on page 4-55.
3. Remove the fuser wiper cover assembly. See “Fuser wiper cover assembly removal” on page 4-54
4. Remove the two screws (A) attaching the upper plenum and remove the upper plenum.
5. Remove the screws from the upper cover. See “Upper cover removal (printer)” on page 4-133.
Note: It is not necessary to remove the cover from the printer.
6. Lift the left rear corner of the printer upper top cover to access the flag (B) and remove the flag from the
mounting bracket.
A
To Next Page
Loading...
