Repair information 4-103
7002-xxx
Integrated tray autocompensator assembly removal
1. Remove the ADF scanner assembly. See “ADF complete assembly removal” on page 4-15.
2. Remove the flatbed scanner assembly. See “Flatbed scan assembly removal” on page 4-38.
3. Remove the paper tray.
4. Remove the left door. See “Printer left side cover removal” on page 4-56.
5. Remove the outer shield. See “Printer outer shield removal” on page 4-126.
6. Place the printer on its back.
7. Disconnect the cannot motor cable (A) from the system board (J24).
To Next Page
Loading...
