Repair information 4-109
7002-xxx
Low voltage power supply removal
1. Remove the redrive assembly. See “Redrive assembly removal” on page 4-128.
2. Remove the right side cover. See “Printer right cover removal” on page 4-58.
3. Remove the pass thru plate. See “Pass thru plate” on page 4-74.
4. Remove the LVPS mounting screws (A) from the rear of the center pan.
5. Disconnect the LVPS to system board cable.
The cable is difficult to disconnect. There are catches (B) that firmly hold latches on the LVPS card
connector (C).
CAUTION
Unplug the printer before you begin.
To Next Page
Loading...
