Diagnostic aids 3-33
7002-xxx
3. Contents will be lost. Continue? appears on the touchscreen. Touch No to cancel or Yes to
proceed. If you select Yes, the printer performs the selected action on the hard disk. The following graphic
appears when the encryption process is selected:
The panel provides many progress indicators during the two-stage process.
• 1/2 indicates that the process is currently in the first stage.
• 0% indicates the progress of the current stage of the process.
• The progress bar indicates the overall completion of the entire process by filling in throughout each
separate stage.
When the first stage of either process completes, the printer displays either of the following graphics
depending on the process selected and then begins the second stage of the process:
The entire process is complete when the progress bar appears completely shaded and the percentage
indicator shows 100%. After completion, the panel returns to Disk Encryption.
Wipe Disk
This setting provides you with a tool for erasing the contents of a disk.
Warning: Wipe Disk removes a disk's data in such a way that it cannot be recovered.
To change this setting:
1. Touch to select Wipe Disk from Configuration Menu.
Note: If an advanced password has been established, you must enter this password in order to change
the setting. If no advanced password exists, you can establish one by using the keyboard that appears on
the LCD.
2. Touch to select Wipe disk now.
Contents will be lost. Continue? appears on the touchscreen.
3. Touch Back to return to EVENT LOG.
4. Touch Yes to continue, or touch No to exit.
To Next Page
Loading...
