3-4 Service Manual
7002-xxx
Touch Exit Diag Menu to exit the Diagnostics Menu and Resetting the Printer displays. The printer
performs a POR, and the printer returns to normal mode.
PRINTER SETUP
Defaults See “Defaults” on page 3-17
Printed Page Count See “Printed Page Count” on page 3-18
Perm Page Count See “Permanent Page Count” on page 3-18
Serial Number See “Serial Number” on page 3-18
Envelope Enhance See “Envelope Enhance” on page 3-18
Engine Setting 1 to 4 See “Engine Setting 1 through 4” on page 3-18
Model Name See “Model Name” on page 3-18
Configuration ID See “Configuration ID” on page 3-19
Edge To Edge See “Edge to Edge” on page 3-19
Par S Strobe Adj See “Parallel strobe adjustment (Par x Strobe Adj)” on
page 3-19
PAR 1 STROBE ADJ (if additional parallel
options are installed)
EP SETUP
EP Defaults See “EP Defaults” on page 3-20
Fuser Temp See “Fuser Temperature (Fuser Temp)” on page 3-20
Fuser Page Count See “Fuser Page Count” on page 3-20
Warm Up Time See “Warm Up Time” on page 3-20
Transfer See “Transfer” on page 3-21
Print Contrast See “Print Contrast” on page 3-21
Charge Roll See “Charge Roll” on page 3-21
Gap Adjust See “Gap Adjust” on page 3-21
EVENT LOG
Display Log See “Display Log” on page 3-21
Print Log See “Print Log” on page 3-22
Clear Log See “Clear Log” on page 3-22
SCANNER TESTS
ASIC Test See “ASIC Test” on page 3-23
Feed test See “Feed Test” on page 3-23
Manual Registration See “Scanner Manual Registration” on page 3-23
Sensor Tests See “Sensor Tests” on page 3-23
Diagnostics Menu tests (continued)
Exit
Diag Menu
Exit
Diag Menu
To Next Page
Loading...
