11. Appendix MX-FR Series Modular Matrix Frames – User's Manual 184
3.4.4
Released: 2014-10-08
New feature
▪ UMX-TPS devices handle the command channel even in disabled receive mode, serial packets are
discarded.
▪
▪ Logging data extended, if VS100 holds I2C SCL line down. VS100_getHpdStatus function added
(previously this register was checked in handler periodically, but it was removed in order to reduce the
number of remote read transactions to prevent VS100 I2C lockdowns).
▪
▪
3.4.5
Released: 2015-01-28
New feature
▪ MX-3GSDI-IB converts every video signal to RGB444.
▪ Plugging a monitor into the FR80's Preview Output caused reloading of factory default EDID to all
inputs.
▪
▪ Factory default IP can be set with controlboard buttons.
▪ Factory EDID revision number has been set to 1.3 instead of 1.4 now. This may prevent compatibility
issues (usually the source didn't see the connected device as audio capable) with old graphics card
drivers.
▪
▪ From now on MX-DVII-HDCP-IB and MXD-UMX-IB cards always send 24bpp signal into the crosspoint
switch. The 36bpp signals caused signal integrity problems in some rare conditions which could result
in audio popping noise.
3.4.6
Released: 2015-07-27
New feature
▪ Added support for MX-HDMI-3D-STEREO-ADDON v20.
▪
▪ If the temperature of the TPS or TPS2 card increases above 80C, it is logged into the SD card.
▪ Added support for MX-3GSDI-IB v20.
▪ Some residual power from the output cards (from the connected sink devices) could keep the CPU
alive in MX-FR80 and MX-FR65 frames even after removing the AC cords. This resulted false alarms on
▪ MX-HDMI-3D-OB and MX-TPS-OB could not handle if one of the DDC lines was broken. It could cause
VTASK RESET and SII9575 errors. Fixed.
▪ MX-FR80 logged a false "MTRI setXpoint" error after crosspoint switching.
▪
▪ AVI Infoframes were set improperly on MX-3GSDI-IB. This caused random video drops with some
displays.
▪ Emulated EDID is updated now if the source user EDID is changed.
▪
3.4.7
Released: 2015-08-14
▪ Fixed MXSC (Status board) CPU LIVE LED blinking.
3.4.8
Released: 2015-12-01
New feature
▪ Added support for MX-AUDIO-OB-A board.
▪ 4K 60Hz 4:2:0 EDID has been added as 113th Factory EDID.
▪ 4K 60Hz 4:2:0 resolution was falsely reported back as 1920x2160p60
3.4.9
Released: 2016-04-22
New feature
▪ Added support for MX-4TPS2-4HDMI-IB cards.
▪ [MXFR-3005] MX-3GSDI-IB did not work if an MX-HDMI-OPT-OB was in the matrix.
To Next Page
Loading...
Need help?
General
