5 Maintenance
Engine
¾ Using a filter wrench, slacken the cap (1) of
the engine oil filter (3) and undo it by hand.
¾ Pull the filter cartridge (2) from the casing.
¾ Catch the oil in a container as it r
uns out of
the oil filter and dispose of it an
d the oil filter
responsibly.
¾ Insert a new oil filter cartridge.
¾ Renew the O-ring in the cap.
¾ Screw on the cap (1) by hand until th
e O-ring
is seated.
¾ Tighten to 25 Nm.
¾ Close the bonnet.
NOTE
After changing the oil and the filter, run the
engine, checking the oil pressure indicator
and the leaktightness of the drain plug and
oil filter. The oil level should now be checked
again, especially after changing the oil filter.
Switch off the engine and leave it to stand for
about a minute before checking the oil level.
118 Operating Instructions – 393 807 1001 EN – 08/2008
To Next Page
Loading...
