Operation 4
Working under load
d3921429
1
¾ Raise the fork quick-release levers(1).
¾ Move the forks further apart or closer to-
gether depending to the size of the load to
be lifted.
Make sure that both forks are equa
lly distant
from the truck centre.
¾ Allow the quick-release levers to engage in
a notch on the fork carriage.
Taking up load
DANGER
When stepping onto the forks when lifted there is an
increased risk of falling and crushing.
For this reason it is not permitted to step onto the
fork arms when lifted without a protective cage.
DANGER
Loads should be arranged so that they do not pro-
ject beyond the edge of the truck loading surface
and cannot slip, topple over or fall off.
If necessary, use a load guard (special equipment).
DANGER
When a load is raised, it is not permitted to stand
beneath the suspended cargo.
Forklifttrucksshouldonlybedrivenwiththeload
lowered and the lift mast tilted back.
¾ Approach the load to be taken up carefully
and as accurately as possible.
Operating Instructions – 393 807 1001 EN – 08/2008 83
To Next Page
Loading...
