Maintenance 5
Engine
Press the STOP switch (15) in the event of
danger.
Only press the STOP switch in an emergency!
The filter must then be fully regenerated again.
An indicator light (13) will illu
minate if there is
a malfunction during regenerati
on. Press the
acknowledgement button (14).
If the error per-
sists, please contact your aut
horised dealer.
¾ Remove the particulate filter from the re-
generator.
¾ Reattach the particulate filter to the truck.
The opening of the tailpipe must po
int to the
right.
¾ Check the filter is securely in place.
NOTE
When closing the quick-locking mechanism
(9), an end limit switch automatically sets the
built-in hour meter to zero.
Checking the particulate filter system
(special equipment)
¾ Check electric contacts for secure position-
ing, corrosion and damage.
¾ Check the combustion air ducts
for damage,
leaks and secure positioning.
¾ Check the fuel-conducting lines and parts
for damage, leaks and secure positioning.
¾ Check that the system functions correctly
(particulate alarm, buzzer, regeneration).
¾ Check burner fastenings for leak
s, defor-
mation and secure positioning
.
¾ Clean the corrugated hose and the connec-
tion angle (fan to the burner).
¾ Check that the filter suspension points are
securely fitted.
¾ Check the exhaust-gas-conducti
ng parts
for leaks.
¾ Clean the air intake pipe on the burner.
Operating Instructions – 393 807 1001 EN – 08/2008 145
To Next Page
Loading...
