5 Maintenance
Consumables recommendations
Inspection and maintenance data
No. Unit
Devices / Consumables
Filling quantity / Set values
1
Engine Engine oil approx. 4.5 l
2 Fuel tank Diesel
Approx. 40.0 l
with heater / air conditioning:
approx. 11.0 l
3
Cooling system Coolant additive / Drinking
water
without heater / air condi-
tioning: approx. 9.0 l
Lift height up to 5000 mm:
Approx. 24.0 l
Lift height from 5000 mm to
6900 mm: Approx. 25.5 l
4 Hydraulic equipment Hydraulic oil
Lift height from 6900 mm to
8000 mm: Approx. 28.0 l
5
Battery
Distilled water
As required
6
Tyres
Air
See sticker on inside of
overhead guard
Front: 170 Nm
7
Wheel fastenings
Tighten
Rear: 460 Nm
8
Load chains / Lift mast
guides
Linde chain spray As required
9
Air conditioning
Refrigerant
1500 grams
Consumables recommendations
Diesel fuel
Only diesel fuels to EN 590 with a cetane
number (CN) not lower than 51 may be used.
The fuel sulphur content must not exceed
350 mg/kg.
If the only diesel fuel available has a sulphur
content of more than 350 mg/kg, the engine oil
change intervals must be reduced as follows:
• At a sulphur content more than 350 mg/kg
and less than 2000 mg/kg = engine oil
change interval 300 operating hours.
• At a sulphur content more than 2000 mg/kg
= engine oil change interval 150 operating
hours.
NOTE
As the ambient temperature falls, the fluidity
of the diesel fuel is reduced due to paraffin
segregation. If "summer" diesel fuels are used
at low ambient temperatures, this can lead to
malfunctions. For this reason, cold-resistant
"winter" diesel fuel is available during the
colder part of the year, which can reliably be
used at temperatures down to about -22°C.
In winter, use only winter diesel fuel, so that
the fuel lines do not become blocked by
segregated paraffin. At very low temperatures
even winter diesel fuel can suffer from this
problem of segregation. Please contact your
authorised dealer.
98 Operating Instructions – 393 807 1001 EN – 08/2008
To Next Page
Loading...
