Introduction 1
Reception of forklift truck
Linde Truck Control
The truck’s Linde Truck Control system (LTC)
provides for:
• Sensitive, smooth driving and re
versing
• Automatic regulation of the engine speed to
match the respective power required by the
hydraulics
• Fast service by means of self-diagnosis
• Optimum operational reliability
.
Brakes
The hydrostatic drive is used as a service
brake. This means that the service brake is
maintenance-free. There are two multi-disc
brakes integrated into the wheel motors, which
are used as a parking brake. The multi-disc
brakes are engaged when the engine is
switched off. This gives the truck an automatic
braking function. The parking brake must
always be activated when the truck is switched
off.
Steering
The steering is a hydrostatic steering system,
under which the steering wheel acts on the
steering cylinder to actuate the rear wheels.
If the power applied to the steering wheel is
increased, the steering system can also be
operated when the engine has been switched
off.
Lift mast
The free-view lift mast enable
s:
• Ideal visibility through slim mast profiles
• Full load capacity up to maximum lift heights
• Enormous residual lifting capa
city
• Maintenance-free bearings for lift mast and
tilt cylinders via rubber-cushioned linkage
points
• Electric tilt angle limitation.
Electrical system
The electrical system is supplied
with 12 V DC
by the alternator. A 12 V battery wi
th 88 Ah is
installed to start the engine. It i
s located under
the driver’s seat in the engine com
partment.
Truck operation when using a sho
vel
When operating the truck with a
shovel, stall
protection can be activated by
your authorised
dealer.
In this case, extreme loading of the drive
engine due to the associated engine speed
decrease leads to a slight delay in executing
the working hydraulics.
NOTE
For a period of extended loadin
gofthe
engine, the joystick must be sw
itched to the
zero position in order to relea
se the working
hydraulics again.
Reception of forklift truck
Before the truck leaves our factory, it is
subjected to a careful inspection to ensure
that it is in perfect condition and is received
by you complete with all equipment according
to your order. Your authorised dealer is also
obliged to perform another inspection and
proper handover.
To avoid subsequent complaints, please be
so kind as to carefully check the condition
of the truck and the completeness of the
equipment yourself and to confirm proper
handover/takeover vis-à-vis your dealer.
Operating Instructions – 393 807 1001 EN – 08/2008 5
To Next Page
Loading...
