4 Operation
Standard equipment
Running-in instructions
The lift truck can be operated at full speed
directly. Avoid sustained high loads on the
working hydraulic system and the travel
drive in the first 50 hours of operation. The
wheel fasteners must be tightened before the
commissioning and after each wheel change.
Thereafter at least every 100 operating hours.
Tighten opposite wheel fasteners to a torque
of
front:
170 Nm
rear:
460 Nm
Checks before starting work
Carried
out
9
8
Engine
Check the fuel level
Check the engine oil level
Checking the coolant level
Chassis frame
Check the tyre pressure
Hydraulics
Hydraulic system: Check the oil level.
Standard equipment
Adjusting the driver’s seat
WARNING
An incorrect adjustment of the seat can cause back
injury. Do not operate the seat adjusting devices
while operating the truck.
Before each start-up of the truck and with each
change in driver, set the weight setting to the indivi-
dual weight of the driver and check if all settings are
correctly engaged. Do not place any objects in the
vicinity of the controls.
26 Operating Instructions – 393 807 1001 EN – 08/2008
To Next Page
Loading...
