Maintenance 5
Inspection and maintenance overview
3000 h Service plan
At operating hours
Carried
out
3000 15000
9
8
Information on service plan
Dependent on the consumables used, driving style and operating conditions, but at
least after 2, 10 and 14 years of service. Refer also to consumables recommendati-
ons.
Preparations
Clean the truck if necessary
Read out error log and delete
Calibrate the drive potentiometer and joysticks
Enter the next maintenance interval
Engine
Change engine oil
Change engine oil filter
Change the fuel filter
Check condition and secure positioning of engine cradle and engine mounting
Change V-ribbed belt
Change toothed belt and tensioner pulley (at latest after 5 years)
Clean water and hydraulic oil coolers
Check the coolant concentration
Change air filter cartridge, check vacuum-operated switch
Change the safety cartridge in the air filter
Change the breather for charge air regulation
Clean the oil bath air filter
Check suction and exhaust pipes for leaks
Check particulate filter system
Clean the pressure control device at the exchangeable particulate filter
Clean the water trap at the exchangeable particulate filter
Gearbox
Axle clamps and wheel motors: Check fastening
Drive axle: Check the side stops
Operating Instructions – 393 807 1001 EN – 08/2008 105
To Next Page
Loading...
