1 Introduction
Service plan before initial start-up
NOTE
For forklift trucks which leave our works
without a lift mast, an additional stop screw
for speed restriction can be found under
the forwards/reversing accelerator pedal
(two-pedal operation) or accelerator pedal
(one-pedal operation. This screw must be
removed after attaching the mast by loosening
the screw and removing it along with the aid of
a hexagonal nut (see also Driving without lift
mast).
Each forklift truck comes with
the following
technical documents:
• operating manual for forklift truck
• EC Declaration of Conformity (manufac-
turer confirms that industrial truck complies
with requirements of EC Machinery Direc-
tive).
• Safety rules for the use of indust
rial trucks
(VDMA)
• Registration document for the industrial
truck, provided on handover by your autho-
rised dealer.
Serviceplanbeforeinitia
lstart-up
Carried
out
9
8
Engine
Fill up with fuel
Check the engine oil level
Checking the coolant level
Regenerating the particulate filter
Chassis frame
Tighten wheel fastenings
Check the tyre pressure
Checking the brake system
Check steering system.
Electrics / Electronics
Battery: check condition, acid level and acid density
Hydraulics
Hydraulic system: Check the oil level.
Check lifting system and attachments.
Check function and safety system of third auxiliary hydraulics
6 Operating Instructions – 393 807 1001 EN – 08/2008
To Next Page
Loading...
