5 Maintenance
Engine
d3941303
2
3
4
5
¾ In the event of an emergency, unlock and
press the stop switch (3) in the switch panel
(1).
NOTE
Regeneration can be performed only when
the engine is stopped and the glow plug start
switch is in the zero position (ignition off).
Regeneration is carried out au
tomatically.
Once regeneration has been com
pleted suc-
cessfully, the switch light (o
peration indicator)
goes out and the truck can be ope
rated again.
¾ Clean the exhaust air duct thoroughly.
¾ If more than 30 minutes have elapsed since
the engine was switched off, move the glow
plug start switch briefly to position I and then
back to the zero position (ignition briefly
switched on, then off again).
The particulate filter control
system will remain
active for a further 30 minutes,
and regen-
eration can be started at any t
ime within this
period.
d3941303
2
3
4
5
¾ Push starting switch (2) downwards and
hold down for approx. 3 seconds until the
built-in yellow switch light illuminates (oper-
ation indicator). The orange indicator light
(5) goes out.
The operation indicator stays lit up until the
end of the regeneration process (approx. 23
minutes).
If a particulate alarm was ind
icated before
regeneration is restarted, t
his remains lit. In
this case full regeneration m
ust be performed
immediately.
142 Operating Instructions – 393 807 1001 EN – 08/2008
To Next Page
Loading...
