Linde H35D - Page 255

Circuit diagrams 7
Wiring diagram
Legend
6A1 Data logger with keypad (Linde Forklift Data
Management), 369-383
:1 − Terminal 30
:2 − Terminal 15
:3 − Earth
:4 − Free input
:5 − Load sensor
:6 − Free output
:7 − Terminal 50
:8 − Starter relay
6A2 Linde Forklift Data Management online
module, 386-391
:3 − Terminal 15
:4 − Earth
6B2 Load sensor, 393-397
:1 − Terminal 15
:2 − Signal
:3 − Earth
F15 5A fuse, 380
6F1 5A fuse, 378
2H1 1.2W lift mast position preselection warning
light, 324
K2 Start relay, 363-366
K3 Engine shutoff relay, 353-356
N1 LHC electronic control system, 321-325,
329-333
S1 Ignition and starting switch, 342-349
2S1 Lift mast position preselection switch,
322-324
2S2 Feed-pressure filter pressure switch, 329
2S3 High-pressure filter pressure switch, 332
V1 Decoupling diode, 359
6W1 Antenna (Linde Forklift Data Management
online module), 390
X1 10-pin plug connector, 342-348, 354, 365
X1.1 10-pin plug connector, 342-348, 354
X10 18-pin plug connector (for basic equipment),
380
X11 9-pin plug connector (for basic equipment),
359, 382
X15 2-pin plug connector (CAN connection),
370, 376
2X1 2-pin plug connector (microfilter), 329, 333
2X2 4-pin plug connector (lift mast position), 322,
324
2X6 2-pin plug connector (pressure switch), 329
2X7 2-pin plug connector (pressure switch), 332
6X4 14-pin plug connector (data logger), 369-
383
6X5 3-pin plug connector (data logger transfer),
378, 380
6X7 5-pin plug connector (data transfer), 376-
380
6X9 4-pin plug connector (Linde Forklift Data
Management online module), 386-388
Wire colours
BK Black
BN Brown
BU Blue
GN Green
GY Grey
OG Orange
RD Red
VT Violet
WH White
YE Yellow
The number in front of the wire colour refers
to the wire cross-section.
Wires with unspecified cross-section = 0.75
mm
2
Notes
(I) Lift mast positioning
(II) Hydraulic oil microfilter indicator
(III) Vehicle deactivation via seat switch
(a) For horn activation 4S1 (basic equipment
wiring diagram)
(b) For electronic controller N1:42
(IV) Linde Forklift Data Management (LFM)
(c) For generator G1:B+
(d) For ignition and starting switch S1:50
(e) For starter motor M1:50a
(f) For brake pedal switch X2:3
Operating Instructions – 393 807 1001 EN – 08/2008 245