Operation 4
Standard equipment
¾ Look at the indicator unit (3).
NOTE
After the ignition has been switched on, the
indicator unit will perform a self-test. The dis-
plays all light up for approx. 2 seconds and
the operating hours until the next service are
displayed for 5 seconds in the indicator unit (3)
display field (12). During this time the symbol
(13) remains lit. After 5 seconds the display
reverts automatically to the operating hours. If
the buzzer sounds (particulate filter unit fault),
check the lights (see Malfunctions, Causes
and Remedies — diesel engine). If the buzzer
continues to sound, please contact your local
authorised dealer. If the symbol (9) flashes
or lights up, the set service interval has been
exceeded. The service that is due must be
performed. Please contact your authorised
dealer.
The following controls ligh
t up:
• Parking brake applied symbol (10)
• Engine oil pressure indicator (6)
• Battery charge indicator (5)
• Glow plug indicator (14)
• Particulate filter symbol (7) (only if a partic-
ulate filter is fitted and the particulate filter
control system is activated).
¾ Wait until the glow plug indic
ator (14) goes
out
¾ Turn ignition key to position "II".
As soon as the engine starts:
¾ Release the ignition key.
Symbol (8) will flash on and off.
CAUTION
Only for trucks with particulate filter units. If the
exhaust continues to be very smoky, switch off the
truck. Please contact your authorised dealer.
Every time the engine is started, watch the exhaust
pipe outlet for about 5 seconds.
If the engine fails to start:
¾ After the glow plugs have heated up, keep
turning the starter motor until the engine
Operating Instructions – 393 807 1001 EN – 08/2008 33
To Next Page
Loading...
