Operation 4
Standard equipment
¾ Place your foot on accelerator pedal (4).
¾ Parking brake (1) actuated (it is only possi-
ble to start the engine with the parking brake
actuated).
• Version 1: Parking brake handle (
1) en-
gaged.
• Version 2: Parking brake lever (16) turned
clockwise until it snaps into place.
¾ Insert ignition key (2) into the ignition and
starting switch and turn from the zero posi-
tion to position "I".
The electrical system is switched
on.
¾ Look at the indicator unit (3).
NOTE
After the ignition has been switched on, the
indicator unit will perform a self-test. The dis-
plays all light up for approx. 2 seconds and
the operating hours until the next service are
displayed for 5 seconds in the indicator unit (3)
display field (13). During this time the symbol
(14) remains lit. After 5 seconds the display
reverts automatically to the operating hours. If
the buzzer sounds (particulate filter unit fault),
check the lights (see Malfunctions, Causes
and Remedies — diesel engine). If the buzzer
continues to sound, please contact your local
authorised dealer. If the symbol (10) flashes
or lights up, the set service interval has been
exceeded. The service that is due must be
performed. Please contact your authorised
dealer.
The following controls light up:
• Parking brake applied symbol (11)
• Engine oil pressure indicator (7)
• Battery charge indicator (6)
• Glow plug indicator (15)
• Particulate filter symbol (8) (only if a partic-
ulate filter is fitted and the particulate filter
control system is activated).
Operating Instructions – 393 807 1001 EN – 08/2008 39
To Next Page
Loading...
