LNC T6 Series User Manual

LNC-Lathe New T6-Series
CNC Operation
100 LNC Technology Co., Ltd.
The Below Table Describes Each Soft Panel Function Selection Switches：
Function
Switches
ON
OFF
M LOCK
The controller will continue executing
program while the program is executing.
But, the moving command of the servo
axis will NOT be outputted. So actually,
the servo axis is completed stop (no
movement).
The moving command of the servo axis
will be outputted with the program while
the program is executing.
DRY RUN
It will follow the parameter’s G01 velocity,
not the program’s velocity(the velocity of
Pr,1004 setting)
The designated speed of the servo feed
program.
OP SKIP
Program begins with ”/” symbol will be
skipped and not be executed.
Single block that begins with ”/” symbol
will be executed normally.
OP STOP
The program will stop when the program
executes up to M01. If want to continue
executing, users need to press ”CYCLE
START”.
Controller will ignore M01 and execute
the next single block directly.
MST Ignore
Ignore M, S, T codes commanding.
Consider M, S, T codes commanding.
MPG DRY RUN
System starts to process, hand wheel can
control the program processing, and the
program coordinate and servo axis to
change together. The faster MPG runs,
the faster program runs. But MPG will not
faster then program feetrate. When MPG
stops, the program will also stop. MPG
CCW will not control program.
Hand wheel can not modify the program
coordinate and let the servo axis moves
according to it.
Z Ignore
Ignore any command from Z Axis
Process any command from Z Axis.

LNC T6 Series Specifications

General

Brand	LNC
Model	T6 Series
Category	Controller
Language	English