LNC-Lathe New T6-Series
CNC Operation
LNC Technology Co., Ltd. 89
1.8.5 Working Parameter Page
When pressing【RST】, monitor’s left side will show buttons as below,【CLRTMR】、【CLRCNT】、【INICNT】、
【MAXCNT】, you can use this buttons to clear operation time and parts.
Cutting Time：When users press “Cycle Start” button on OP, cutting time will reset to zero and then start timing
until the part program finishes.
Working Time：Working time is the sum of cutting time every time rebooting. It will be set to zero until exit
(returns to zero). Using 【RST】 + 【RUNTIME】 will return the working time back to zero
immediately.
Working Piece：When CNC has read M02, M03 or other M codes, the system will adding up the working piece
automatically. Using 【RST】 + 【PARTCONT】 will return the working piece number back to
zero.
Figure 1.8-8 Working Parameter Page
To Next Page
Loading...
