LNC-Lathe New T6-Series
CNC Operation
LNC Technology Co., Ltd. 79
1.8 DGNOS
Pressing <DGNOS> and 6 main function screens occur, which are 【ALARM】, 【IOCSA】, 【MLC2】,【SYSTEM】,
【COMM】,【SYSU】 and 【CIRCUL】. Users are able to know the condition of HMI signal and machine condition
from the DGNOS function screen in order to do the maintenance and the system testing.
1.8.1 ALARM
Clicking【ALARM】to enter into the 【ALARM】, 【WARN】, 【HISMSG】 and【LOGHST】. When there is
any alarm message or warning message from MLC, the alarm message will occur on the screen. Users can use
this screen to remove any irregular condition of the controller.
Figure 1.8-1 ALARM screen
【ALARM】Alarm message will occur when there is any problem in system running. This will make the system
stop running and also will display the alarm message on the screen. When the problem is solved,
must press <RESET> in order to release the situation.
To Next Page
Loading...
