LNC T6 Series User Manual

LNC-Lathe New T6-Series
OP Panel Operation
116 LNC Technology Co., Ltd.
(6). （JOG）
Users can move axis by choosing moving direction, but the moving speed is decided by feed speed.
2.5 SPINDLE ROTATION& SPINDLE SPEED ADJUSTMENT SWITCH
Spindle Operation Buttons
Under manual mode,（here means JOG、RAPID、MPG）, spindle’s rotation can be controlled by this three buttons.
CW ：Spindle CW
STOP ：Spindle Stop.
CCW ：Spindle CCW
Under this manual mode, no matter the spindle is CW or CCW, the rotation command will be between 0% ~
120%, one more thing you need to be careful is when changing the rotation direction, you need to press STOP
first, otherwise this change will be not effective.
Spindle Speed Adjustment Buttons
When spindle at auto or manual mode, use M3（or M4）to make spindle start to rotate, spindle’s exact rotation
speed can be adjusted by UP＋ and DOWN－ buttons. Rate can be from 0% to 120%. For example, after giving
a command as M3 S1000, and adjust button is at 120%, the exact rotation will be 1200PRM.And if you set it to
be 10%, press 100％ button, and the exact rotation speed will become 1000PRM.
（JOG）
FEEDRATE BUTTON
+X，+Y，-Z，-C

LNC T6 Series Specifications

General

Brand	LNC
Model	T6 Series
Category	Controller
Language	English