LNC-Lathe New T6-Series
OP Panel Operation
120 LNC Technology Co., Ltd.
b. Manual executing in MDI mode
Users can key-in a block of program commanding such as G91 G01 X100. Z100 in MDI mode, then press
“CYCLE START” button to execute this single block command. The intension of this executing mode is
different than that of MEM mode, which is always used in testing some motion. The light will remain ON during
executing time until the executing is finished
FEED HOLD
Press this button to stop program executing temperately. During the pause time, “FEED HOLD” light will be ON.
M, S and T will remain in the current condition. Please press the “CYCLE START” button again in order to
continue executing the unfinished program
2.9 Feedrate/Rapid Rate Adjusting Button
This is the feedrate/rapid rate adjusting button
FEEDRATE：
When making servo axis feeds by G01…F…command in MEM or MDI mode, the actual feedrate can be
adjusted period by period, between 0% to 150%, by this button. For example, the assigned F100 means the
feedrate is 100mm/min. But, if adjust this button to 50%, the actual feed rate is only 50mm/min. This button
works for servo feedrate under JOG mode on multiple machines. When Dry Run mode is effective, this button
will adjusts the feedrate too
To Next Page
Loading...
Need help?
General
