To Next Page

To Previous Page

LNC-Lathe New T6-Series

RS232 COMMUNICATION SOFTWARE

146 LNC Technology Co., Ltd.

3.4.3 Path Program Upload & Save (using general software)

1. Edit RS232 setting at controller and PC end, and make sure they are coordinate.

2. Use PROG group, change to EDIT mode.

3. Go to【DIRMNG】and choose the file that you want to transfer to PC end and press [DOWN LOAD].

Select 1. General software to upload.

4. Go to Communication page and press [COMM] at the down right side.

Questions and Answers:

Need help?

Do you have a question about the LNC T6 Series and is the answer not in the manual?

LNC T6 Series Specifications

General