LNC T6 Series User Manual

LNC-Lathe New T6-Series
CNC Operation
LNC Technology Co., Ltd. 105
1.10.4 NET SET
Press【NET SET】to enter this page, the page will show two ways for you, such as 【NET】and【ReCON】。
The operation method is as below：
Change to <PARAM>, press【CHGUSR】and change to machine maker level and input P651 and press INPUT,
system will search P651and set this parameter to be as below（0 means NET method；1 means ReCON method）,
after setting, please reboot the system.
The connection of【NET】and the PC setting：
【SAVE】： Follow below line to complete and press save to save setting.
【RECONNECT】： After【SAVE】, press EMG( emergency stop button) and press【ReCONNECT】, the system
will reconnect again.
Definition as below：
Controller Name：This is the controller’s name in the net, different controllers will have different names, and the
name can not be the same with the PC’s. Its default name will be LNCDOS, therefore if there
are many controllers in the same Net area, you will need to modify this section.

LNC T6 Series Specifications

General

Brand	LNC
Model	T6 Series
Category	Controller
Language	English