LNC T6 Series User Manual

LNC-Lathe New T6-Series
RS232 COMMUNICATION SOFTWARE
124 LNC Technology Co., Ltd.
3.2 PC end Installation (Use LNC ReCON 232 Software)
1. Clicks CD> Software\ ReCON-232 V1.25.0010, or double click setup.exe icon, the driver will start to install
automatically.
2. According to Wizard’s direction to follow next step or click the items to continue.
3. After installation, the desktop will have an icon of ReCON – 232, also at the start> program file.
PC end
1. After installation, click ReCON – 232 Icon at the desktop, or press the button at start/ program file.
2. Press Start, below window will show on the screen.
3. Press Setup, below window will show on the screen.
4. Users can move the mouse cursor to the right side’s table list to select transmission mode. The setting here
needs to be the same with PARAM setting at the machine, otherwise, the transmission may fail.
After communication setting, press OK, at this time, Start button will pop out. Press Start to complete PC end’s
preparation.

LNC T6 Series Specifications

General

Brand	LNC
Model	T6 Series
Category	Controller
Language	English