LNC-Lathe New T6-Series
RS232 COMMUNICATION SOFTWARE
140 LNC Technology Co., Ltd.
3.4 Communication （RS232）-【 DNC file upload and download functions 】
3.4.1 Path Program Upload & save (using ReCON software)
This is a device that could make you transfer the file from PC end to NC end and also save the file at NC
end(H.DD/Disk ON Chip/Disk ON Modular), Details as below：
Operation for NC&PC end
1. Edit RS232 setting at controller and PC end, and make sure they are coordinate.
2. Use PROG group, change to EDIT mode.
3. Go to 【DIRMNG】 and choose the file that you want to transfer to PC end and press [DOWN LOAD]
Select 1. LNC ReCON 232 software to upload.
To Next Page
Loading...