LNC T6 Series - Path Program Upload & Save (Using General Software)

To Next Page

To Previous Page

LNC-Lathe New T6-Series

RS232 COMMUNICATION SOFTWARE

150 LNC Technology Co., Ltd.

3.4.4 Path Program Upload & Save (using general software)

1. Edit RS232 setting at controller and PC end, and make sure they are coordinate.

2. Use PROG group, change to EDIT mode.

3. Go to 【DIRMNG】 and choose the file that you want to transfer to PC end and press [UP LOAD].

Select 1. General software to upload.

Related product manuals