To Next Page

To Previous Page

LNC-Lathe New T6-Series

RS232 COMMUNICATION SOFTWARE

LNC Technology Co., Ltd. 143

3.4.2 Path Program Upload & save (using ReCON software)

Operation Steps for NC&PC end

1. Edit RS232 setting at controller and PC end, and make sure they are coordinate.

2. Use PROG group, change to EDIT mode.

3. Go to [DIRMNG] and choose the file that you want to transfer to PC end and press [UP LOAD].

Select 1. LNC ReCON 232 software to upload.

Questions and Answers:

Need help?

Do you have a question about the LNC T6 Series and is the answer not in the manual?

LNC T6 Series Specifications

General