To Next Page

To Previous Page

LNC-Lathe New T6-Series

OP Panel Operation

114 LNC Technology Co., Ltd.

2.2 LED SIGNAL

1：X/Y/Z/C AXIS ZRN

2：CONTROLLER ALARM

3：POWER ON, LED ON

4：LUBRICATION INSUFFICIENT, LED ON

2.3 AXIS SELECTION

These buttons are used to command moving axis direction under JOG and ZRN modes.

For example, pressing +X key under JOG mode, it will move to +X direction, and release this key, it will stop

moving. Other axis has the same functions.

Press +X under ZRN mode, X axis will go plus direction to return home. Other axis has the same functions.

2.4 MODE SELECT

Questions and Answers:

Need help?

Do you have a question about the LNC T6 Series and is the answer not in the manual?

LNC T6 Series Specifications

General