Loadrite L2180 - 2.3 Accurate weighing

2.0 Introduction
2.3 Accurate weighing
Formaximumaccuracy,ensurethat:
n
CheckZeroisperformedregularly.
n
Loadliftingmotionissteadyandsmooth,withnoaccelerationorbounce.
n
Thebucketisfullyrolledbackduringthelift.
n
Theloaderisonlevelground.
TIP – IftheGround Slope Compensationsensorisinstalled,theloaderdoesnothaveto
belevelwhenlifting.
2.3.1 Obtaining the best weighing results
Lifting speed
Forbestresults,operatetheliftleverbeforeacceleratingtheenginesothatthemachinedoesnotrockasitlifts,
i.e.usenormalrevs.
Trigger Point
StarttheliftwellbelowtheTriggerPoint.Thisensuresthatallaccelerationandloadbouncehasbeeneliminated
wellbeforetheweighingsequencebegins.
NOTE – WerecommendthatthereareatleasttwosecondsofliftbeforepassingtheTriggerPoint.
Bounce
Mostloadershavepneumatictireswhichcancausethemachinetobouncewhenlifting.
Tominimizetheeffectofbounce,alwaysoperatetheliftleverbeforeacceleratingtheengineandstartthelift
wellbelowtheTriggerPoint.
Center of gravity
Thehydraulicpressureintheliftingcylindersdependsonwherethecenterofgravityoftheloadis.Itisimportant
thatthebucketisalwaysinthesameposition:fullyrolledback.
Loadrite L2180 loader scales | 15