Loadrite L2180 - 16.0 Appendix C: Error Messages; 16.1 Bouncing load

16.0 Appendix C: Error Messages
16.0 Appendix C:
Error Messages
Errormessagesmaybedisplayedforavarietyofreasonsasdetailedbelow:
16.1 Bouncing load
Iftheliftarmsarebouncingsignificantlywhileweighing,anerroroccurs.Thiscanhappenif,forexample,the
loaderisdrivenoverunevengroundwhileliftingtheload.
DependingontheinstallationoftheparticularLoadriteWeighingSystem,therearetwopossibilities:
n
Noweightisdisplayedandthereforethereisnoweighttoadd.Repeatthelift.
n
WeighingError isturnedoffandaweightisdisplayed.Addtheweighttothetotal(bearinginmindthatthe
weightmeasurementisnotreliable)orignorethisweightandrepeattheliftsmoothly.
16.2 Bucket back?
Thebucketmustbecrowedfullybackforeachlift.TheBucket back? messagewillbedisplayediftheLoadrite
WeighingSystemhasnotdetectedthatthebucketisfullycrowdedback.
NOTE – ThismessageshouldonlybedisplayedwhenusingaLegalforTradescale.
16.3 Bucket empty?
Ifthebucketiszeroedandthereissomeresidueinthebucket,theLoadriteWeighingSystemwilldetecthow
muchisinthebucket.Ifthecontentsarelessthan5%ofthefullbucketcapacity,theLoadriteWeighingSystem
willzerothebucket.Iftheweightofproductinthebucketiswithin5-10%offullbucketcapacity,theIndicatorwill
displaytheBucket Empty?messagetoconfirmthezero.
n
Tozerothebucket,press .
16.4 Bucket not back
Thebucketmustbecrowedfullybackforeachlift.TheBucket not back messagewillbedisplayedifthe
LoadriteWeighingSystemhasnotdetectedthatthebucketisfullycrowdedback.
NOTE – ThismessageshouldonlybedisplayedwhenusingaLegalforTradescale.
Loadrite L2180 loader scales | 81