Loadrite L2180 - What Is Auto-Add

3.0 The day-to-day weighing process
3.
Press toaddthebucketloadtotheshorttotal.
Amessagewilldisplaythenumberofbucketsaddedtothecurrentload,forexample
Bucket added. Add #1.

NOTE – If isnotpressedwithin8(eight)secondsoftheloadbeingliftedpasttheTriggerPoint,
theIndicatorwillbeepandtheWeight Discardedmessagewilldisplay.Theweightwillthenbe
discardedandthe Total screenwilldisplay.
Whentheloadhasbeenadded,the Total screenwilldisplaywiththenewshorttotalandthenumberof
addedbucketloads.
4. Emptythebucketloadintothetruck.
3.6.1 What is Auto-Add?
The Auto-Add functionality is only available if enabled at installation.
TheLoadriteweighingsystemcanbesettoautomaticallyaddabucketloadwhenliftedpasttheTriggerPointfor
aspecifiednumberofseconds OR whenthebucketisrotatedforwardtotipofftheload.Thismeansthatyou
don'tneedtopress afterliftingeachload.
ThefollowingmayapplydependingonhowAuto-Addfunctionalitywasconfiguredatinstallation:
n
Bucketloadsmaynotbeaddedifunderaspecifiedamount.
n
Auto-Add maybeturnedonoroffviathe SetupMenu orbypressing (Auto-Addtoggle).
3.6.1.1TurnAuto-AddOnorOff
1.
Press .
The SetupMenu willdisplay.
2.
Press or toscrollupordownuntil Auto-Addisselected,thenpress .
3. Completethefollowing:

If you want to... Then...
turn Auto-Add on
usethearrowbuttonstoselectOn,thenpress .
turn Auto-Add off
usethearrowbuttonstoselectOff,thenpress .
4.
Press toreturntothe Total screen.
Loadrite L2180 loader scales | 21