Loadrite L2180 - Uplink; Uploading a Configuration File Via a EDP Cable; Uploading a Configuration File Via a Loadrite Data Module; Standby

13.0 Setup Menu
13.17 Uplink
Thisoptionisusedtouploadaconfigurationfilecreatedusing LoadriteToolbox viaaLoadriteDataModuleor
fromaPCviaaEDPcable.Theconfigurationfilecontainsproductnames,datalistsandsettings.
n
Forinformationoncreatingaconfigurationfile,refertothe LoadriteToolboxUserManual .
13.17.1 Uploading a configuration file via a EDP
cable
1.
Fromthe UplinkMenu selectEDP,thenpress .
TheIndicatorwillenter Uplink mode.
2.
WhenthemessageUplink Readyisdisplayed,use LoadriteToolbox tosendtheconfigurationfile.
n
ThemessageUpdatingandacounterwilldisplayastheIndicatorreceivestheconfigurationfile.
n
LoadriteToolbox willdisplayamessagetoindicatethattheuploadiscomplete.
3.
Press toexit Uplink mode.
13.17.2 Uploading a configuration file via a
Loadrite Data Module
1.
Fromthe UplinkMenu selectData Module,thenpress .
2. ConnecttheLoadriteDataModulecontainingtheconfigurationfiletotheIndicator.
3.
WhentheSync Config From Module?messagedisplays,press .
AcounterwilldisplayastheIndicatorreceivestheconfigurationfile.
4.
WhentheDelete Config From Module?messagedisplays,press .
TheconfigurationfilewillbedeletedfromtheDataModule.
13.18 Standby
ThisoptionputstheIndicatorinto Standby mode.TheIndicatorwillalsogointo Standby modeifitisnotusedfor
twohours.
n
Pressanybuttontoexit Standby mode.
Loadrite L2180 loader scales | 75