Loadrite L2180 - 3.8 How do I finish the load?; 3.9 How do I put the Indicator into Standby mode?

3.0 The day-to-day weighing process
3.8 How do I finish the load?
Whenyouhavefinishedaddingbucketloadstothetruck,youmustcleartheshorttotal.
Tocleartheshorttotal,completethefollowing:
n
Pressandhold .

Theshorttotalwilldisplaybriefly,followedbytheTotal Clearedmessage,thenthe Total screen.
IfaprinterisconnectedtotheLoadriteWeighingSystem,aticketoftheloader’stotalswillbeprinted.
Formoreinformationontheshorttotal,see"The short and long totals"onpage31.
3.9 How do I put the Indicator into Standby
mode?
IfyouarenotgoingtousetheLoadriteWeighingSystemforawhile,youcanputtheIndicatorinto Standby 
modebycompletingthefollowing:
Option 1
n
Pressandhold for5seconds.
TheIndicatorwillenter Standby mode.
Option 2
1.
Press .
2.
Press or toscrollupordownuntilStandbyisselected,thenpress .
TheIndicatorwillenter Standby mode.
Option 3
TheLoadriteIndicatorwillautomaticallygointo Standby modeifitisnotusedfortwohours.
How do I exit Standby mode?
n
Pressanybuttontoexit Standby mode.
Eitherthe Login screenor Total screenwilldisplay.
Loadrite L2180 loader scales | 26