Loadrite L2180 - 6.4 Blend mode

6.0 Operation Modes
6.4 Blend mode
Blend mode is only available if selected at installation.
Blend modeissimilarto Batch modeexceptthattherecipecontainsthetotalnumberofloadsrequiredforeach
product,ratherthanatargetload.
Whenyouloadthefirstproduct,yourLoadriteWeighingSystemwillautomaticallychangetothenextproduct
whentherequirednumberofliftshasbeenreached.
Arecipecancontainuptotenproducts.
Blend mode process
1.
Enter Blend mode.
2. Selectthecurrentrecipeorenteranewrecipe.
3. Selectthefirstproductandloadituntiltherequirednumberofliftsisreached.
4. TheLoadriteWeighingSystemwilltrackthenumberofliftsandpromptyouwhentochangeproducts.
5. Selectthenextproductandweigheachbucket-loaduntilyouarepromptedtochangeproducts.
6. Repeatstep5foreachproductintherecipeuntilallproductshavebeenloaded.
Example: Blend mode calculation
Arecipeofthreeproductsandthenumberofloadsrequired.Duringweighing,theLoadriteWeighingSystem
willguideyouthroughtheprocess,resultingin26loads.
Product Loads
Sand 6
Gravel 10
Pumice 10
6.4.1 How do I enter Blend mode and select a
recipe for the batch?
1.
Press ,thenscrollifrequireduntilBlend Mode?isdisplayed.
2.
Press .
TheBlend Recipemessagewilldisplay.
3. Completethefollowing:
If... Then...
theRecipe Emptymessage
displaysbriefly,beforedisplaying
the Product screen
thereisnorecipeavailable.
n
Toenteranewrecipe,see"How do I enter a new recipe?"on
page49.
Loadrite L2180 loader scales | 48