Loadrite L2180 - Speed Changed

16.0 Appendix C: Error Messages
16.26 Speed changed
Foraccuratemeasurement,thespeedofraisingtheliftarmsmustbesmooth,withoutaccelerationor
deceleration.TheLoadriteWeighingSystemcandetectchangingspeedasthearmsgopasttheTriggerPoint.
DependingontheinstallationoftheLoadriteWeighingSystem,therearetwopossibilities:
n
Noweightisdisplayed,andthereforethereisnoweighttoadd.Repeattheliftandavoidacceleratingand
deceleratingatorneartheTriggerPoint.
n
Aweightisdisplayed.Addweighttothetotal(acknowledgingthattheweightmeasurementisnotreliable)
orignorethisweightandrepeattheliftsmoothly.
16.27 Speed too high
Thismessagedisplaysifthespeedofraisingthearmsistoofastandexceedspredefinedlimits.
Liftthearmsagainslower.Ifthemessagedisplaysagain,theremaybeafaultinthesystem.TheLoadrite
WeighingSystemshouldbecheckedand,ifnecessary,re-calibrated.
16.28 Tilt too high
Theangleoftheloaderisatanunsaferollorpitchwhileweighing.TheTilt Too Highmessageaccompanies
thespecificrollorpitcherroratthetopbarofthedisplay.
16.29 Too heavy, zero aborted
Iftheweightofproductinthebucketisgreaterthan10%offullbucketcapacitywhen ispressed,thescreen
displaysthismessageanddoesnotalteranysettings.Thispreventsanyaccidentalzeroingofvalidweights.
NOTE – Ifthebucketisemptyandthemessagestilloccurs,theremaybeafaultinthesystem.The
LoadriteWeighingSystemshouldbecheckedand,ifnecessary,re-calibrated.
16.30 Warm-up lift
ThismessagedisplaysiftheIndicatorhasbeenturnedoffformorethanonehour,promptingawarm-uplift.
Loadrite L2180 loader scales | 85