Loadrite L2180 - Auto-Tare Value Look-Up; Prompt

5.0 Product Management
5.2.1.2Usinganindexnumbertoviewatrucktargetvalue
TheLoadriteWeighingSystemcanbeconfiguredsothatanindexnumbercanbeusedtolookupthetargetfor
aparticulartruck
Followingisanexampleofanindexedtruckandtargetlist.Data 4hasbeenconfiguredasatargetlistwiththe
indexfunctionenabled.Theindexnumbersareusedtoidentifyeachtruck.
Index Data 4: Target
1(AAT053) 25.000
2(ABT384) 16.000
3(AUS994) 15.500
4(YE9444) 22.500
5(UK9900) 22.000
1.
Press .
The DataMenu willdisplay.
2.
SelectTarget,thenpress .
The Target screenwilldisplay.
3.
Usethekeypadtoentertheindexnumberofthetruck,thenpress .
Thetargetforthetruckwillbedisplayed,thenthe Total screenwillbedisplayed.

5.2.2 Auto-tare value look-up
Thisfunctionissimilarto Auto-targetvaluelook-up ,exceptthatithandlestarevalues.Itispossibletorecallthe
tarevaluefrommemorybyeitherenteringanumberorscrollingthroughalistoftrucknames.Theprocedures
arethesameasthe Auto-targetvaluelook-up functionality.
5.2.3 Prompt
The Prompt functionality is only available if selected at installation.
Thisfunctionwillautomaticallypromptfordatafieldentrieswhenanewproductisselectedorthecurrentshort
totaliscleared.
Loadrite L2180 loader scales | 38