Setting Unit Policies
www.lsi.com/channel/products 103
The page refreshes, and a message at the top confirms the change you
have made.
If your system has no BBU, a message will caution you about enabling
write cache.
To enable or disable unit write cache through 3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
Enter.
An asterisk appears in the left-most column to indicate that it is selected.
2
Tab to the Maintain Unit button and press Enter.
3 On the pop-up menu, select
Configure and press Enter.
4 In the Configure Disk Array screen, Tab to the field Write Cache
Settings
.
Figure 59. Unit Write Cache State in 3BM
The current setting—Enabled or Disabled—is shown. (The initial default
setting is for write cache to be enabled.)
5 Press
Enter to display the choices, use the arrow keys to select the
setting you want, and press
Enter again to choose it.
6Tab to the
OK button and press Enter to select it.
You return to the main 3BM screen.
7 When you are finished making changes, press
F8 to save them and exit
3BM.
To Next Page
Loading...
Need help?
General
