Chapter 5. 3DM2 (3ware Disk Manager 2) Introduction
58 3ware SATA+SAS RAID Controller Card Software User Guide, Version 10.2
Setting Up 3DM2 Preferences
The 3DM2 Settings page lets you define preference settings that affect the
overall operation of 3DM2.
On the 3DM2 Settings page you can perform the following tasks:
• Setting and Changing 3DM2 Passwords
• Managing E-mail Event Notification
• Enabling and Disabling Remote Access
• Setting the Listening Port #
• Setting the Frequency of Page Refreshes
• Controlling Command Logging in 3DM2
Setting and Changing 3DM2 Passwords
3DM2 provides different access levels for users and administrators.
The Administrator access level allows the user to fully configure 3DM2. The
User access level allows the user to view pages within 3DM2. These
passwords work independently of each other.
The default password for both the User and Administrator is “3ware”.
Passwords are case sensitive.
You can only change passwords only if you are logged in as Administrator. If
you change the Administrator password, you are automatically logged out,
and must log back in with the new password.
Enclosure Details
page
Shows details about a particular enclosure, including status
information. You also can use this page to blink the LED for a
particular drive.
To view this page, click the ID number of the Enclosure on the
Enclosure Summary page.
3DM2 Settings
page
Lets you set preferences, including email notification for
alarms, passwords, page refresh frequency, whether remote
access is permitted, whether command logging is enabled,
and the incoming port which 3DM2 will use for listening.
To view this page, click 3DM2 Settings on the menu bar.
Table 7: List of 3DM2 Pages
3DM2 Page Description
To Next Page
Loading...
Need help?
General
