About Controller Policies
www.lsi.com/channel/products 67
To see information about a controller in 3BM (BIOS)
1 Power up or reboot your system.
2 While the system is starting, watch for a screen showing information
about the controller and units you want to work with.
When you have more than one controller installed, information about
each one will be shown, sequentially.
3 Press
Alt-3 or 3 to bring up the 3ware BIOS Manager (3BM).
4
Tab to Information and press Enter.
5 On the pop-up menu, select
Controller and press Enter.
The Controller Information page displays.
Figure 31. Controller Information page
About Controller Policies
The following policies affect all units and drives on a controller and can be
adjusted as appropriate for your equipment. Controller policies are shown at
the bottom of the Controller Settings page in 3DM2 (Figure 32) and on the
Policy Control screen in 3BM (Figure 33).
•
Auto-Rebuild. Determines whether the Auto-Rebuild policy is enabled or
disabled. When disabled, degraded units can only be rebuilt with
designated spares. When enabled, the controller firmware will
automatically attempt to rebuild a degraded unit if there is no spare, using
either an available drive or a failed drive.
Note: If you accidentally bypass display of the controller you want to
work with, press
Ctrl-Alt-Del to restart your computer and try again
To Next Page
Loading...
Need help?
General
