Setting Unit Policies
www.lsi.com/channel/products 109
• Under FreeBSD use the fsck command.
• Under Linux use the fsck command.
• Under Mac OS X, you can use the First Aid tab in the Disk Utility—
select the disk on the left and then click
Verify Disk. If verification
encounters problems, you can then use the
Repair Disk option on the
same screen.
• Under OpenSolaris you should follow your operating system’s guide to
perform a file system check.
• Under VMware you should follow your operating system’s guide to
perform a file system check.
• Under Windows, you can do this by right-clicking on the Drive and
choosing Properties; then on the Tools tab, click Check Now.
To set the Overwrite ECC policy in 3DM2
1 Choose
Management >> Controller Settings from the menu bar in
3DM2.
2In the
Unit Policies section of the Controller Settings page, check the
boxes to select the policies you want to be in effect for each unit
The page refreshes, and a message at the top confirms the change you
have made.
To set the Continue on Source Error When Rebuilding policy in
3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
Enter.
An asterisk appears in the left-most column to indicate that it is selected.
2Tab to the
Maintain Unit button and press Enter.
3 On the pop-up menu, select
Configure and press Enter.
4In the
Configure Disk Array screen, Tab to the field Continue on
Source Error When Rebuilding
.
5 Press
Enter to display the choices, use the arrow keys to select the
setting you want (Enabled or Disabled), and press
Enter again to choose
it.
6
Tab to the OK button and press Enter to select it.
You return to the main 3BM screen.
To Next Page
Loading...
Need help?
General
