MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-56Upgrading the System
2
Print to Floppy Disk 2
Use the arrow keys to highlight *272)/233<: and press
1
. Use one of the
methods shown below.
■ To print the reports to a floppy disk if the print file does not exist, use the
arrow keys to highlight 0$.(1(:),/( and press
1
.
— To save to the default print filename (SULQWDPV), press
1
.
— To save to the filename of your choice, type [
filename
] and
press
1
.
■ To print the reports to a floppy disk if the print file already exists, use the
arrow keys to highlight the filename and press
1
.
Upgrading the System 2
!
WARNING:
The following procedures are to be used by qualified technicians or service
personnel only. Installation or maintenance of this product by anyone other
than qualified personnel may damage or impair the product; your limited
warranty does not cover such damage. For details, see your limited
warranty in Appendix A “Customer Support Information” in the back of this
book.
Hazardous electrical voltages are present inside this product.
This section describes upgrading your communications system to Release 6.1.
You can use this procedure to perform the following upgrades:
■ From Release 1.0 to Release 6.1
■ From Release 1.1 to Release 6.1
■ From Release 2.0 to Release 6.1
■ From Release 2.1 to Release 6.1
■ From Release 3.0 to Release 6.1
■ From Release 3.1 to Release 6.1
■ From Release 4.0 to Release 6.1
■ From Release 4.1 to Release 6.1
■ From Release 4.2 to Release 6.1
■ From Release 5.0 to Release 6.1
■ From Release 6.0 to Release 6.1
MERLIN II Communications System programming cannot be upgraded to this
communications system. The new communications system must be completely
reprogrammed.
To Next Page
Loading...
Need help?
General
