Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-57Upgrading the System
2
Before You Begin 2
Before you begin the upgrade to Release 6.1, you will need the items listed below.
■ Any version of SPM to backup system programming information.
■ SPM Version 6.25 or later to convert and restore system programming
information.
NOTES:
1. If SPM is already installed, the :HOFRPHWR630 screen that
appears when you start SPM identifies the version on both the
last line of the console simulation window and in the upper left
corner of the screen. If you are working with Version 6.25, 9
appears in the upper left-hand corner of the screen and 9HUVLRQ
 appears on the last line of the console simulation window.
2. The version of SPM packaged with Intuity does not support
conversion. The most current version of SPM is available for
download from NSAC.
■ A processor module with a PCMCIA memory card slot (if one is not already
installed in the system).
■ An R6.1 Forced Installation PCMCIA Memory Card.
NOTE:
If a new processor module is installed as part of the upgrade
procedure, the system software is already installed. The R6.1 Forced
Installation memory card is only required if upgrading a system and
the processor module is not replaced.
Inter-Release Compatibility 2
It is important to understand compatibility between files created on each of the
different versions of SPM, not only for upgrading but also for programming.
Table 2–6
summarizes programming compatibility. (It is assumed that the majority
of the programming is done in surrogate mode and backed up on disk).

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English